How to Display Crafting Through The Apocalypse Sticker
By Badge Bomb | buttons, pins, stickers + gifts by your favorite | Published: 2026-10-22
Category: How-to Guides
Learn the best ways to show off your Crafting Through The Apocalypse sticker on laptops, water bottles, and more, with practical placement tips and common mistakes to avoid.
Quick Answer
For best visibility and durability, place your Crafting Through The Apocalypse sticker on a clean, smooth, and slightly curved surface like a laptop lid or a reusable water bottle, and use the steps below to avoid bubbles and peeling.
Why Surface Choice Matters
The Crafting Through The Apocalypse sticker is weather-resistant and kiss-cut for extra protection, but its longevity depends on where you put it. Smooth, non-porous surfaces like metal, glass, or hard plastic give the adhesive the best grip. Avoid rough or textured surfaces like fabric or unfinished wood, which can cause the edges to lift over time.
Trade-Off: Laptop vs. Water Bottle
A laptop lid offers a large, flat canvas that keeps the sticker safe from direct water exposure, but the constant opening and closing can stress the sticker's edges. A water bottle sees more handling and washing, but the slight curve helps the sticker conform and stay put. Choose based on whether you prioritize visibility (laptop) or daily ruggedness (bottle).
How to Apply Your Sticker Without Bubbles or Peeling
- Clean the Surface Thoroughly: Wipe the area with isopropyl alcohol or a mild soap solution to remove oils, dust, and residue. Dry completely with a lint-free cloth. A common mistake is applying to a surface that looks clean but still has hand oils, which cause the sticker to lose adhesion within days.
- Position Before Peeling: Hold the sticker (still on its backing) over the surface to check alignment. Use a piece of painter's tape to hinge one edge if you need a guide. Common mistake: peeling the whole backing at once, making it impossible to reposition without creasing.
- Apply from Center Outward: Peel a small section of the backing from one corner, press that corner down, then slowly peel the rest while smoothing the sticker with a credit card or squeegee. Work from the center to the edges to push out air. A common mistake is pressing from the edges inward, which traps bubbles in the middle. If a small bubble remains, poke it with a pin and smooth it flat within the first hour.
- Let It Cure Before Handling: Wait at least 24 hours before washing, submerging, or placing the item in a bag. The adhesive needs time to bond fully. A common mistake is using the item immediately, which can cause the sticker to shift or peel at the edges.
About This Sticker
- Crafting Through The Apocalypse Sticker: The Crafting Through The Apocalypse Sticker is weather-resistant, long-lasting, and kiss-cut for extra protection. It measures approximately 2.5 x 2.4 inches and is made in the USA. Its weather resistance makes it suitable for outdoor gear like water bottles or bike frames, while the kiss-cut design means the backing peels off cleanly without tearing the sticker.
Crafting Through The Apocalypse Sticker
